888-893-3308 10am - 4pm EST Mon - Fri
Halor JR 4 TIR LED Grille and Surface Mount LightHalor JR 4 TIR LED Grille and Surface Mount LightHalor JR 4 TIR LED Grille and Surface Mount LightHalor JR 4 TIR LED Grille and Surface Mount Light
$45.96 $31.96
Average rating based on 0 review(s)

About The Halor JR 4 TIR LED Grille and Surface Mount Light

The surface mount HALO JR ‘4’ has just THAT...4 Generation III 1-Watt LEDs that are made to last 100,000 hours. That’s 4 Watts of long lasting light that comes in your choice of 5 solid colors or 3 split-color combinations. It has a tough, polycarbonate housing with an aluminum heat-resistant backing. The HALO JR 4, like the rest of the HALO JR Series, also has polycarbonate TIR lenses that stay bright and clear and don’t fog up. TIR lenses produce a strong, steady focused beam that lights up the area around your first responder unit and can be seen from over a mile away, so those approaching know they should slow down and heed any warnings. 5 colored wires come attached to the light for easy installation: Pos, Neg, Sync, Pattern, and HI/LO. It has 22 flash patterns that ‘burst,’ ‘split,’ ‘alternate,’ ‘cycle flash’ and more. The California “Steady” meets that state’s requirements...and the HALO JR 4 has pattern memory, too! Mount the HALO JR 4 on the dash or deck of your vehicle, or because they are sealed with high-tech epoxy and are 100% waterproof, mount them on any exterior flat surface (grille, bumpers, roof, or body) of your patrol car, SUV, or on whatever you drive. It comes in black and a surface mount flange, a gasket, and hardware are included.

Features:

  • (4) 1-Watt Generation III LEDs
  • 22 Flash Patterns with Pattern Memory
  • Interior/Exterior Vibration Resistant Surface Mount Light
  • 100% Waterproof
  • 5-Year Limited Warranty on LED Bulbs
  • 2-Year Limited Warranty on Components
  • Meets or Exceeds SAE J845 & J595 Standards
  • Meets or Exceeds California Title 13 Requirements

Included in Box:

  • HALO JR 4
  • Surface Mount Flange
  • Screws
  • Rubber Gasket

The HALO JR 4 is vibration resistant, so put it as low or as high on the exterior of your professional or volunteer unit that you want, and with the shatterproof polycarbonate lenses, it can take a whole lot of rough use off road and on. The HALO JR Series surface mounts are almost always bought in pairs so they can be put opposite each other. If you plan to mount them yourself, be sure to refer to the Installation Guide in the Knowledge Base section of our website, and REMEMBER to ALWAYS read through the entire procedure BEFORE you start.

Product Demo

Video Coming Soon!

Mounting Options

  • Surface Mount Front Locations
  • Surface Mount Rear Locations
  • Surface Mount Light Side Locations