888-893-3308 10am - 4pm EST Mon - Fri
Halo JR 3 TIR LED Grille and Surface Mount 10 Multi-Pack

Halo JR 3 TIR LED Grille and Surface Mount 10 Multi-Pack

Model: [ hljr3-10pck ]
$169.96   $349.60
$169.96   $349.60

Available Options:

Unit 1 Color:

Unit 2 Color:

Unit 3 Color:

Unit 4 Color:

Unit 5 Color:

Unit 6 Color:

Unit 7 Color:

Unit 8 Color:

Unit 9 Color:

Unit 10 Color:

About The Halo JR 3 TIR LED Grille and Surface Mount 10 Multi-Pack

Each Halo JR 3 has 3 Generation III 1-Watt LEDs, that’s 30 Watts of bright light when you buy a 10 Multi-Pack.  You’ll be highly visible to approaching motorists with that much light pulsating from the surface of your first responder vehicle.  The TIR lenses are made of crystal clear polycarbonate material that won’t yellow or fog up. Polycarbonate is also used in the housings which are backed with a heat-resistant aluminum shields. Mount the Halo JR’s on any flat surface on the inside or outside of your emergency vehicle: on the deck or dash, grilles, bumpers, roof, or body.  They are 100% waterproof because they are sealed with industrial grade epoxy and have the IP-67 rating. The “3” has 22 flash patterns and comes with pattern memory.  Choose from 5 solid colors.  Mounting flanges, hardware, and gaskets are included. Hardwire them to an existing light or siren system with the color-coded wires that come wired into each light. The Halo 3 JR’s can be synchronized or wired to flash simultaneously; they also alternate.


  • (3) 1-Watt Generation III LEDs/Unit
  • 22 Flash Patterns with Pattern Memory
  • Interior/Exterior Vibration Resistant Surface Mount Light
  • 100% Waterproof meets IP-67 Rating
  • 5-Year Limited Warranty on LEDs
  • 2-Year Limited Warranty on Components
  • Meets or Exceeds SAE J845 & J595 Standards
  • Meets or Exceeds California Title 13 Requirements
  • IP-67 Rating

Included in Box:

  • 10 HALO JR 3
  • 10 Surface Mount Flanges
  • 10 Rubber Gaskets
  • 20 Screws


3.75"W x 1.46"H x 1"D

Because most customers install surface mount lights in pairs, the 10 Multi-Pack is the best and most economical way to buy them. ETD always recommends having a EVT specialist install our lights, but if you are a DIY kind of person, be sure to check out the Installation Guide found in the Knowledge Base section of our site before you start. Check out the ACCESSORIES SECTION, too;  you find all you need at great prices to do the installation.  Of course, if you have any problems just contact us through our website or through your favorite social network.

Product Demo

Video Coming Soon!

Mounting Options

  • Surface Mount Front Locations
  • Surface Mount Rear Locations
  • Surface Mount Light Side Locations